User`s manual
12
18. SOLUTION TANK
Remove the front inlet cap and confirm the solution filter is correctly installed.
Confirm the filter cap (beneath the solution tank, at the back) is correctly
closed.
19. SOLUTION TANK
Fill the tank with clean, room temperature water through the front fill location
(1).Watertemperaturenottoexceed120°F(50°C).Youcancheckthelevelof
solution in the tank by reviewing fluid level in the sight tube (2).
Add the liquid detergent into the tank, in the concentration and manner speci-
fied by the manufacturer. The formation of excess foam could damage the
vacuum motor, so be sure to use the correct concentration of detergent.
WARNING: Always use low-foam detergent. Introduce a small
amount of defoaming chemical in the recovery tank before start-
ing to work to prevent foam from being generated.
WARNING: Never use acids.
20. MOUNTING THE BRUSH
A. With the brush deck up, place the brush under the brush deck and position it
in line with the clutch plate beneath the brush deck.
B. Lower the brush deck, turn the key (1) to position “1”, pull the levers (2) on
the handlebars.
The brush will automatically attach to the drive under the brush deck.
WARNING: Make sure there are no objects or people in the vicin-
ity of the brush when doing this operation.
MACHINE PREPARATION