User`s manual

7
3. BATTERY INSTALLATION
The machine will be supplied with a battery charger and either two 12V Wet or
AGM batteries. The batteries must be housed in the battery tray in the battery
compartment beneath the recovery tank.
Toinsertthebatteriesyoumust:
A. Lower the squeegee and brush deck.
B. Open the rear latch (2) that secures the tank.
C. Rotate the recovery tank as far as it will go, using the side handle (3).
WARNING: To avoid acid spillage you can use sealed batteries.
WARNING: Perform one battery charging cycle before using the
machine.
4. TYPE OF BATTERY
Topowerthemachineyoucanuse:
• Wetbatteries
• AGMbatteries
• Gelbatteries
OTHER TYPES MUST NOT BE USED.
Themaximumbatterydimensionsandtheweightare:
Width 6.7 in (171 mm)
Length 12.9 in (329 mm)
Height 9.6 in (245 mm)
Weight 68 lb. (31 kg)
WARNING: Your charger and battery check card must be set ac-
cording to the type of battery you install. Call BETCO customer
service to ensure correct charger setting after replacement bat-
teries are installed.
• Thebatteriesmustbehandledusingliftingandtransportationmeanssuitable
for the weight and dimensions.
• Theymustbeconnectedtogetherinseries,toobtainanoverallvoltageof
24V on the lugs.
• Theelectricalconnectionoperationsmustbecarriedoutbycertiedtrained
personnel.
MACHINE PREPARATION