User`s manual

MACHINE PREPARATION

16. ADJUSTING THE SQUEEGEE HEIGHT

The height of the squeegee must be adjusted based on wear and tear of the squeegee

blade. To do this, turn the knobs (2) counter clockwise to raise the squeegee, and

clockwise to lower it.

Note: the right and left wheels must be adjusted to the same level, so the squeegee

can work parallel to the floor.

17. ADJUSTING THE SQUEEGEE INCLINATION

During working operation, the rear squeegee blade is slightly tilted backwards (by

about 0.2 in (5mm) in a uniform way for its entire length. If it is necessary to increase

the bend of the squeegee blade in the central part, you must tilt the squeegee

backwards, rotating the adjuster (1) counter clockwise. To increase the bend of the

squeegee blade at the sides of the squeegee, rotate the adjuster clockwise. When fully

adjusted, tighten the jam nut.

18. RECOVERY TANK

Check the drain hose cap (on the rear of the machine) to ensure it’s closed.