User`s manual

MACHINE PREPARATION
19. SOLUTION TANK
Remove the front inlet cap and check the solution filter is correctly fitted.
Check the filter cap (beneath the solution tank, at the back) is correctly closed.
20. SOLUTION TANK
Fill the tank with clean water in the front fill location (1) at a temperature not exceeding
120°F (50°C). You can check the level of solution in the tank by means of the rear
hose (2).
A
dd the liquid detergent into the tank, in the concentration and manner specified by the
manufacturer. The formation of excess foam could damage the vacuum motor, so be
sure to use only the correct amount of detergent.
WARNING: Always use low-foam detergent. Introduce a small
amount of anti-foam detergent in the recovery tank before
starting to work to prevent foam from being generated.
WARNING: Never use pure acids.
1
2