User`s manual

TROUBLESHOOTING GUIDE

INSUFFICIENT WATER ON THE PAD

1. Check the valve – located beneath the symbol – (1) is turned on.

2. Check there is water in the solution tank.

THE MACHINE DOES NOT CLEAN WELL

1. Check the state of wear and tear of the pad and, if necessary, replace it.

2. Use a different kind of pad to the one fitted as standard. For cleaning floors where

the dirt is particularly resistant, we recommend the use of special brushes supplied

upon request and according to needs (see “CHOOSING AND USING THE

BRUSHES”).

THE SQUEEGEE DOES NOT DRY PERFECTLY

1. Check the squeegee blades are clean.

2. Adjust the inclination of the squeegee (see "SQUEEGEE" under “MACHINE

PREPARATION”)

3. Ensure the vacuum hose is correctly inserted in its housing on the recovery tank.

4. Check the inner filter of the recovery tank to ensure it is not dirty and, if necessary,

clean it thoroughly.

5. Disassemble the entire vacuum unit and clean it.

6. Replace the squeegee blades, if worn.

7. Ensure the vacuum motor switch is turned on.

8. Check wheel adjustment.

TOO MUCH FOAM IS GENERATED

Check that low-foam detergent is being used. If necessary add a small amount of anti-

foam liquid to the recovery tank.

Remember that more foam is generated when the floors are not very dirty. Dilute the

detergent more when cleaning floors that are not very dirty.