Installation Guide

DETERMINE ORIENTATION
If installing horizontally, swivel Hanger A one-
quarter turn to align it with Hanger B. (Figure A)
APPLY RUBBER BUMPERS
Adhere bumpers near the bottom corners of the
back of the mirror.
MEASURE THE HANGERS
Measure the distance between the centers of
the D-ring hangers.
MARK WALL LOCATION
Using a level and the previous measurement,
mark the locations of the mounting hardware
on the wall. (Figure B)
INSTALL HARDWARE
For drywall and concrete walls, use a 1/4-inch
drill bit to drill pilot holes. Insert each anchor
into the holes until flush with the wall surface.
For solid wood walls, drill pilot holes using a 1/8-
inch drill bit (anchors are not necessary). Install a
screw into each anchor until the head of the
screw is approximately 1/4-inch off the wall.
HANG MIRROR
Attach the D-ring hangers to the wall-mounted
hardware. (Figure C)
Figure A
A B
Figure B
WallHoles
Figure C
Installation Guide