Installation Guide

1. Place mirror in the desired location on the wall. Mark a line on the wall at the top
center of the mirror (two people are required for this step). Carefully set the mirror
aside when complete.
2. Position the Wall Bracket so that the top of the bracket is 4-1/2 inches below the
Top of Mirror Line from step #1. Use a level to ensure the Wall Bracket is level, then
mark the positions of the Wall Bracket Screw Holes.
Note: The ridges on the Wall Bracket should be against the wall and the screw
holes should be on the bottom. See illustrations.
3. Using a ¼-inch bit, drill pilot holes into the marked locations. Insert the provided
anchors until flush with the wall surface. Place the Wall Bracket onto the wall and
secure with the provided screws.
4. Carefully hang the mirror by placing the Mirror Mounting Plate onto the Wall
Bracket. Positioning can be adjusted side to side by gently sliding the mirror
along the bracket.
ILLUSTRATION
Mirror Outline
Top of Mirror Line
(Step #1)
4-1/2 inches
(Step #2)
Wall Bracket Screw Holes (see reverse)
Installation Guide