User Manual

IMPORTANT! !PL EA SE READ ENTIRE
IN ST RUCTION SHEET BEFORE ASSEM BLY!!
PARTS LIST
A
B
C
D
E
BASE
1
1
EXTENSION
POLE
1
METAL WASHER
1
Caution: Although you have an umbrella base. We highly recommend you to remove
your umbrella from umbrella base and table when not in use. Strong winds or severe weather
conditions still could tear the umbrella and damage the umbrella or the table even with
a closed umbrella. In this case, the parts would not be covered under warranty.
Warrens Umbrella Base
NUT
Iden t ify all p arts packed i n the carton against the parts list. Remove all prot ective
mat erials. Place parts on a non-abras ive surfac e. If yo u are m iss ing any p arts or
are un sure how to proceed with assembly, please call custome r service center
im m ediatel y at 844-836-4055 (Monday-Frid ay, 9:am -5: 00pm CST) or e-mail:
[e-mail]
Do not attempt to assemble the product if any p arts are missing o r damaged .
Step 1
Gently insert the extension pole (B) into the hole pre-drilled in the base (A), secure extension pole
with base with nut (D) and metal washer (C).
Tighten nut by using your Hex Wrench (E).
Step 2
Your umbrella base is now ready for use. Carefully insert the umbrella pole through the hole
in the center of the table, and if applicable, also through the hole in table connector bracket,
and then into the base.
Turn the screw already placed in the extension pole till your umbrella pole is secured in
the extension pole.
1
HEX WRENCH
STEP 1