User Manual

ASSEMBLY INSTRUCTIONS
ATTENTION: THIS PRODUCT IS NOT FOR COMMERCIAL USE
INTENDED FOR RESIDENTIAL USE ONLY.
PARTS LIST
PAGE 1 OF 3V-3
FIGURE 1
COURTYARD CREATIONS INC.
PART
NO.
MATERIAL CODE PART Q’TY
PART
NO.
MATERIAL CODE PART Q’TY
1 1
1
1
1
1
1
2
2
4
4
1
4
1
1
1
10
11
12
13
14
15
16
17
18
WASHER d6.5*D30*2.0
WASHER d8.5*D12*2.1
WASHER d8.5*D17*1.6
JAM NUT M8*1.25
2
3
4
5
6
7
8
9
20-RVS093Z
RVS093Z-CS01-2
RVS093Z-CS01-3
RFS8821-CS04
RVS093Z-CS12-1
18000744004
17C40A0714001YX
17C40A0708001YX
4
17C03A0814041YX
Attention:
Make sure that each bolt needed for all steps
matches the corresponding figure to ensure proper
assembly.
Note:
The labels marked “L” and “R” on arms (#2 and #3)
should coincide with Figure 1 to ensure proper
assembly.
SERVICE CENTER TOLL FREE NO.
TEL: [phone]
FAX: [phone]
Use the correct bolts as indicated. Do not tighten any of the bolts until the swivel chair is completely assembled.
Do not discard of any of the packaging until you have checked that you have all of the parts and fittings required.
Keep children away during assembly. This item contains small parts that can be swallowed by
children. Children should always be under direct adult supervision while using this product.
Retain these assembly instructions for future reference.
Quote the following FQC No. when contacting the service center.
!
!
!
!
!
17FA08060601-YX
HEX. KEY WRENCH 6MM
NUT WRENCH 10 & 13MM
SEAT CUSHION
17FC08030801-YX
17FA05100701-YX
17D03A040401-YX
17KAA0201----Y4
1
HEX. KEY WRENCH 4MM
17KAA0101----Y4
17KAB1101----Y4
61R093ZC00001BA
RVS093Z
BOLT M8*40
CHAIR ASSEMBLY
RIGHT ARM
SEAT POST
BASE ASSEMBLY
BOLT M6*20
BOLT M6*40
LEFT ARM
DECORATIVE
PLASTIC COVER
Step 1:
Place the right arm (#3) onto a non-abrasive surface,
such as a carpet. Insert arms (#2 and #3) into the chair
assembly (#1) and fasten together by using bolts
(#7). Keep the bolts loose. See Figure 1.
1
17C40A0712001YX
BOLT M6*35
STOP DO NOT RETURN TO THE STORE!
40
2
1
1
2
3
7
#7 BOLT M6*40
L
R