User Manual

Assembly Instructions

1. Unpack the unit and confirm that you have all the hardware and required parts.

2. Lay one Chair Backrest (A) on a smooth and protective surface with the threaded holes facing up.

3. Attach one Seat Frame (B) to the Chair Backrest (A) with the end dowel fully inserted. Make sure the

Seat Cushion

will face up when the unit is turned upright. Insert the 80 mm Bolts (2) with Lock Washers

(3) and Flat Washers (4) through the drilled holes on the seat frame at rear corner blocks and loosely

tighten into the threaded inserts on the Backrest (A).

4. Secure the Seat Frame (B) to the Chair Backrest (A) by inserting two 40 mm Bolts (1) with the Washers

(3 and 4) through the drilled holes on the rear rail of the Seat Frame.

DO NOT fully tighten the bolts or nuts initially until all the bolts or nuts are

ready to assemble. To avoid causing damages to the thread, DO NOT over-tighten the nuts or bolts.

Lock Washer

(6 used in this step)

③

Flat

Washer

(6 used in this step)

④

M8 x 80 mm Bolt

(4 used in this step)

②

M8 x 40 mm Bolt

(2 used in this step)

①