Instructions / Assembly

11
III. Buckles
A. External Buckles
The external buckles are used to connect the REAR WALL PANEL to the LEFT SIDE WALL
PANEL and RIGHT SIDE WALL PANEL. Also the external buckles are used to connect the
FRONT WALL PANEL to the LEFT SIDE WALL PANEL and RIGHT SIDE WALL PANEL. (see
Figure 2)
Figure 2
B. Wood Guide Inserts on the Floor Panel
The wood guide inserts (quarter round moldings) indicated by the arrows in the diagram below are
located on the FLOOR PANEL. The wall panels will sit snugly up against these wood guide
inserts. Notice the cut outs on the left and right side of the FLOOR PANEL towards the rear of the
FLOOR PANEL. These cut outs are for the BENCH HEAT EMITTER PANEL to slide into. (see
Figure 3)
Figure 3
IV. Panel Descriptions
For easier installation, please understand and distinguish the differences between each panel.
A. Floor Panel
Some models have wood braces that must be installed on the underside of the FLOOR
PANEL before assembling the sauna room. (see Figure 4 below) When you place the
FLOOR PANEL at its designated location, leave enough space so that you are able to move
around the FLOOR PANEL in order to install the sauna wall panels. To identify the front of the
FLOOR PANEL, see the diagram below. (see Figure 5 below)