Operating Guide

Figure 4

V. Panel Descriptions

For easier installation, please understand and distinguish the differences between each panel.

A. Floor Panel

When the floor panel faces upward, you will find (5) raised moldings with (3) notches. Three of the

sides will have buckles. The front side will have no buckles. (see Figure 5)

Figure 5 (Floor Heater is towards the front)

B. Understanding The Difference Between The Top And Bottom Of The Wall Panels

The (2) rear panels are in the upright position when the vertical slot on the right rear panel (for the

heating emitter panel below the bench) align with the notch on the floor panel and when the

horizontal bench guide on the left rear panel is closer to the bottom of the panel than the top.

Also, the heater cords will come out of the wall panels at the top. (see Figure 6) The left side

and right side panels (panels with glass inserts) have directional stickers indicating the top. As for

the front panel, the control panel is located at the top of the panel. Please note the location of the

heater cords.