Operating Guide

Figure 6

C. Understanding The Difference Between The Inside And Outside Of The Rear Panels

You will find the heat emitters on the inside of the rear panels. You will find the buckles on the

outside of the rear panels.

Assembly Instructions

A. Choose a good location to assemble the sauna

1. The location must be dry, leveled, and away from any source of water

2. MAIN POWER cord must be easily accessible

3. Two adults are required for installation

4. Wood cabin installation order: Floor Panel Right Side Rear Panel Left Side Rear Panel

Right Side Panel Left Side Panel Bench Emitter Panels Bench Roof Panel Roof

Cover

5. Tools Required: Philips Screwdriver and Ladder

PLEASE NOTE THAT SOME MODELS WILL VARY IN ASSEMBLY.

B. Installing the FLOOR PANEL

1. Place the FLOOR PANEL on the floor. Some models have wood braces that must be

installed on the underside of the FLOOR PANEL. Please check to see if such wood braces

were packed in the box containing the FLOOR PANEL. If so, mount according to the

designated labels located on the underside of the FLOOR PANEL. Once installed, turn the

FLOOR PANEL right side up. Make sure the front side of the FLOOR PANEL is facing the

correct direction. (see Figure 7)

Figure 7 (Floor Heater is towards the front)