Operating Guide

C. Installing the REAR PANELS

1. Remove the protection paper from the buckles. Attach the LEFT SIDE REAR PANEL to

The RIGHT SIDE REAR PANEL while the panels are sitting on the FLOOR PANEL. (see

Figure 8)

Figure 8

D. Installing the LEFT and RIGHT SIDE PANELS

1. Determine the correct placement of the LEFT and RIGHT SIDE PANELS by matching each end of

the buckles on the LEFT SIDE and RIGHT SIDE PANELS with the buckles on the REAR PANELS.

Then attach the RIGHT SIDE PANEL to the REAR PANEL. Do the same procedure and attach the

LEFT SIDE PANEL to the other REAR PANEL. (see Figure 9 and

Figure 10)

Figure 9 Figure 10

E. Installing the BENCH EMITTER PANEL, BENCH PANEL and BENCHES

1. Locate the (2) square wood frames that have two cutouts on one side and a vertical slot on the

other side. Place one of the wood frames next to the glass window with the two cutouts facing the

glass window and the vertical slot facing towards the front. The cutouts fit along the glass window

moldings. The wood frames are not interchangeable and so make sure you have them next to the

correct glass window. Do the same with the second wood frame next to the other glass window.