Operating Guide

2. Slide down the BENCH EMITTER PANEL by lining up its sides with the vertical guides on the

side panel and wood frame. The emitter grid will face outward (toward the front of the sauna) and

the cord will be at the bottom of the emitter grid on the inside (between the BENCH EMITTER

PANEL and the REAR PANEL). Push the BENCH EMITTER PANEL all the way down until it is

touching the FLOOR PANEL and is secured in place. Do the same with the shorter bench panel.

(see Figure 11)

3. Plug in the BENCH EMITTER connector to the corresponding inlet located on the REAR

PANEL. Also plug the floor emitter connector to the corresponding inlet on the other REAR

PANEL. (see Figure 12)

4. Install the BENCHES by sliding them over the horizontal bench guides on the side panels.

Push the BENCHES all the way in until they touch the REAR PANELS and are secured in place.

Make sure to install the BENCHES with the smooth and finished sides facing up. (see Figure 13)

Figure 11 Figure 12 Figure 13

PLEASE NOTE: HEATER STYLES MAY VARY.

G. Installing the FRONT PANEL

1. Place the FRONT PANEL onto the recessed area on the FLOOR PANEL. Align guides on the

LEFT SIDE PANEL with the guide inserts on the FRONT PANEL. The LEFT SIDE PANEL will

need to be lifted in order to lock the guide inserts on the LEFT SIDE PANEL into the guides on the

FRONT PANEL. Secure in place by pulling down on the FRONT PANEL. Make sure all the

guides are locked in place and the top of the LEFT SIDE PANEL is even with the FRONT PANEL.

Do the same with the RIGHT SIDE PANEL. (see Figure 14)

Please Note: You may need

to undo the buckles on the

REAR WALL PANEL in order

to lift the SIDE PANELS up

and onto the FRONT PANEL.

Figure 14