Operating Guide

3. Press the up/down arrows under the TIME DISPLAY to adjust the amount of time you want the

sauna to remain on. Press the C/F button to choose between Celsius and Fahrenheit. Press the

up/down arrows under the TEMPERATURE DISPLAY to adjust the temperature setting. Once you

have set these adjustments to the desired settings, press the START/WORK button. If you don’t

press the button for 5 seconds, the control panel will stop flashing and the set-up values will be

memorized. The WORK and HEAT lights will now be on and the emitters will now be generating

heat. You will need to pre-heat the sauna room to the set temperature before entering. Please

keep in mind that you will increase the time it takes for the sauna room to reach the set

temperature if you enter the sauna room before it has reached the set temperature.

4. During your sauna session, set-up time will count down the minutes one by one. When the time

remaining is 5 minutes, the buzzer will make a warning sound for approximately 15 seconds letting

you know you only have 5 minutes remaining. At this point, you can let the time run out or adjust

the time by pressing the up/down arrows under the TIME DISPLAY. If you do choose to adjust the

time, the control panel will flash and the emitters will stop generating heat. Once you set the time

to the desired setting, then press the START/WORK button twice and the control panel will stop

flashing and heat will began coming from the emitters once again.

5. Heating times do vary. Generally, it will take approximately twenty to thirty minutes to preheat the

sauna to 50 degrees Celsius / 122 degrees Fahrenheit. When the ambient temperature is low,

heating requires additional time. For the first few times of use, you may use 46 degrees Celsius /

115 degrees Fahrenheit as a reference starting point for a time period of about 15 minutes (this

represents the actual time you are in the sauna at the desired temperature). As you become more

comfortable and familiar with the sauna, you can increase the temperature and time period

according to personal preference.

6. When the temperature is at the set-up value, the digital control will maintain the set temperature.

The WORK light will remain on and the HEAT light will turn off. The emitters will stop generating

heat. Once the inside temperature drops approximately 4 degrees, the HEAT light will turn back

on and heat will again be generated by the emitters. With the digital control, the inside

temperature will always remain around the set-up value.

7. Reading lamps and/or roof lamps and/or color therapy lamps are operated by pressing the

respective buttons located towards the center of the control panel. These lamps are offered on

some models and are not available on all models.

8. Chromotherapy/Color Therapy Lighting (optional) can be operated as follows. First, you

will need to install the battery. Once the battery has been inserted into the remote, you are

ready to operate the chromotherapy/color therapy lighting system. Press the READING LIGHT

button on the sauna control panel. The white light will come on. While pointing the remote at

the ceiling light, you can press any of the colors on the remote and that color will be displayed.

You can use the SHADE button on the remote to go through a sequence of colors. If you want

to turn the light off during your sauna session, you can press the POWER button on the

remote. Please note: You must be inside the sauna room for the remote to work.