Operation Manual

15
too tightly, around the arm, and fix
it with the Velcro fastener. The cuff
should be fitted tight enough to
allow just two fingers to fit beneath
the cuff.
Insert the cuff tubing into the socket
for the cuff attachment.
Important: The instrument should
only be operated with the original
cuff. The cuff is suitable for an arm circumference of 23
to 33 cm.
Correct posture
• Rest for approx. 5 minutes before each measurement.
Otherwise there may be divergences.
• You can perform the measurement either sitting or lying
down. Always make sure that the cuff is on a level with
your heart.
• In order not to distort the result, it is important to keep
still during the measurement and not talk.
Select memory
Switch on the blood pressure monitor with the “ ” button.
Select the required memory space by pressing the func-
tion key “+” . You have two memories (60 memory spaces
each) in order to save the test results of 2 different people
separately, or else save measurements in the morning and
evening separately.
Measuring blood pressure
• Put on the cuff as described previously and assume the
position in which you want to carry out the measure-
ment.
• Using the buttons “+”, select the user memory 1 or 2.
Start the measurement process by pressing ON/OFF but-
ton “ ”. After checking the display with all digits lighting
up, the monitor will automatically inflate. Following the
self-test, during which all display elements briefly appear,
the measurement begins. During inflation the device al-
ready determines measured values used to estimate the
required inflation pressure. If this pressure is insufficient,
the device automatically inflates by another.
• Then the pressure in the cuff is slowly released and the
pulse is measured.
• When the measurement has been completed, the remai-
ning air pressure is released very quickly. The pulse, the
systolic and the diastolic blood pressure are displayed.
• You can interrupt measurement at any time by pressing
the ON/OFF button “
”.