Owners Manual

User Manual for DD Refrigerators Beverage-Air
Rev. 12/20Beverage-Air10
KEG INSTALLATION
Safety First! If in doubt about how to handle the CO2 system contact your dealer/distributor
How to Install a CO2 Regulator and Replace an Empty CO2
Cylinder
1. Shut o gas pressure to dispenser by closing the Cylinder
Valve and the Shut o Valve.
2. Loosen the Adjustment Nut (counter-clockwise) and then
unscrew the Adjustment Screw (counter-clockwise) as far
out as it will go to put the regulator in the ‘O’ position.
3. Remove the regulator from the cylinder by loosening the
Gold Regulator Nut.
4. Remove the dust cap from the new cylinder and attach
the regulator to the new cylinder with the Gold Regulator
Nut. Make sure all sealing washers are in place before
connecting.
5. Open the Cylinder Valve all of the way. This is important because the cylinder valve seals in two places.
6. Screw the Adjustment Screw counterclockwise until the required pressure is reached on the Pressure Gauge.
7. Open the Shut O Valve
1. Connect the line from the pressure source to the
Female MFL Fitting using a hose clamp.
2. Align the Sanke Coupler with the lugs in the beer keg
and insert.
3. Turn the Sanke Coupler ¼ turn clockwise until tight in
the keg.
4. Rotate the Handle down 90° to assure the gas ports
in the keg are fully opened.
5. Open the pressure source
How to tap a keg with a Sanke device.