hb series manual

ManualsBrandsBeverage-Air ManualsCommercial EquipmentSolid Half Door Heavy Duty Refrigerator

809-095A

Rev. B

Beverage Air®

IMPORTANT

INFORMATION

FOR

MM and HB SERIES

MMR/MMF/HBR/HBF/MMRF/HBRF

This cooler has passed the

QUALITY CONTROL INSPECTION

And meets the high standards at Beverage-Air

This inspection includes complete refrigeration

system, cabinet construction & finish.

IMPORTANT

PLEASE RETAIN FOR YOUR RECORDS

SALES OFFICE: 3779 CHAMPION BLVD., WINSTON - SALEM, S.C. 27105

PHONE: (336) 245-6400 TOLL FREE 1-800-845-9800

TECHNICAL SERVICE: 1-800-684-1199

PARTS ORDER FAX: 1-800-262-9381

CORPORATE OFFICE: WINSTON-SALEM, NC

MANUFACTURING FACILITY: BROOKVILLE, PA.

Summary of content (6 pages)

PAGE 1
Beverage Air IMPORTANT ® INFORMATION FOR MM and HB SERIES MMR/MMF/HBR/HBF/MMRF/HBRF This cooler has passed the QUALITY CONTROL INSPECTION And meets the high standards at Beverage-Air This inspection includes complete refrigeration system, cabinet construction & finish. IMPORTANT PLEASE RETAIN FOR YOUR RECORDS SALES OFFICE: 3779 CHAMPION BLVD., WINSTON - SALEM, S.C.
PAGE 2
Beverage-Air ® INSTALLATION AND OPERATING INSTRUCTIONS 1. INSTALLATION a. Receiving Inspection: Upon receipt, check all packages for accessories or optional components, including legs, caster, shelves or pan slides. Keys for door locks are attached to one of the doors. (When lock is installed.) b. Legs & Casters: Each cabinet is provided with four threaded legs or casters shipped separately (in some models only). Legs and casters screw directly into the weld nut provided in each corner of the base.
PAGE 3
d. Temperature Control, Defrost System and Condensate Disposal: All H series are equipped with an electronic control. This control is located on right hand side of the cabinet above the door. The control has four buttons as shown in the picture below. Freezers are shipped from the factory with control set at -3 °F and refrigerators are shipped with control set 34 °F. To change the temp control setting, press and hold the Set button for 3 seconds. The set value will be displayed and °F will start blinking.
PAGE 4
Figure 1
PAGE 5
Bi-pin Florescent Lamp Installation / Verification (Glass Door Models Only) a: Visual verification can be made on units without safety shields by using the identification mark on the end of the bulb. Properly installed bulbs will have the mark centered between the halves of the lamp holder. (See Pictures 1 and 2 below) b: On units with shields, the identification mark cannot be seen. Physically verify that the lamp has been rotated and locked into place.
PAGE 6
SERVICE RECORD