User's Manual

General
Communication LTE CAT M1 / CAT NB1/NB2
Battery Operating Voltage: 3.35 – 4.35V±0.02V
Built-in rechargeable battery (Lithium-Polymer). Rechargeable via Micro-USB cable.
Charge: 0℃~ +45℃ In-use: -30℃~ +60℃
Location
GPS Receiver Gen9 VT of Qualcomm (GPS, GLONASS, BeiDou, Galileo and QZSS). Tracking & Navigation: –157
dBm Cold start: –146 dBm Hot start: –157 dBm
Wi-Fi Receiver For Micro-location purpose only. Frequency: 2.4 GHz to 2.4835 GHz, Sensitivity: - 70 dBm
Cellular
Data LTE CAT M1 Packet Data (CoAP/UDP)
CAT NB1/NB2 Packet Data CoAP/LwM2M/UDP
Operating
Bands
and Carriers
North America & Europe: Cat M1 /NB1(2)
M1: LTE-FDD: B2/B3/B4/B5/B8/
B12/B20
NB1/NB2: LTE-FDD: B2/B3/B4/B5/B8/
B12/B20 (AT&T, Bell, T-Mobile, Europe)
SIM MFF2 (embedded SIM)
Sensor Operation Range (full accuracy)
Environmental Temperature [ -30, +60;
Absolute accuracy ±0.5 °C ]
Humidity [ Absolute
accuracy ±3 %RH ]
Pressure [ 300...1100 hPa,
Absolute accuracy ±1 hPa ]
3-Axis
Accelerometer
Motion
Copyright © 2020 BeWhere Inc. All rights reserved.
BeMini Technical Specifications
Physical
Dimensions 57 x 36 x 20 mm 2.24 x 1.4 x 0.79 inches
Weight 0.1 lb (50 gr)
Environmental Operating Range
Temp -30C to +60C
Humidity
95% R.H. @ 50C non-
condensing
Certification
Certifications: FCC/IC, CTIA (PTCRB/OTA) Vibration and Shock*: MIL-STD-810G
Network Targets*:
North America: T-Mobile, AT&T, Bell Ingress Protection*: IP67
International/Europe: MVNO, Deutsche Telekom, Telia, Orange, Vodafone
Compliance Statement
A separation distance of 20 cm must be maintained between this device and nearby persons.
Une distance de séparation de 20 cm doit être maintenue entre cet appareil et les personnes à proximité.
FCC statement: “This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.”
“Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this
equipment.”
IC statement:
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-
exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et Développement économique
Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :
(1) L’appareil ne doit pas produire de brouillage;
(2) L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.