User Manual

Aventho wireless – Headphones
10
Pairing and clearing the list of players
If there are already several players in the list of your Aventho wireless and your Aventho
wireless cannot be paired with another new player, the list is full and should be cleared
so that the new player can be added.
This is how to clear the list:
• Hold down the button  of the turned off Aventho wireless for more than 10 seconds,
so that the Aventho wireless will switch into the pairing mode and clear the list of
players simultaneously.
Multi point operation
The Aventho wireless can be paired to up 8 Bluetooth enabled devices. Active connec-
tions can be established with up to two devices at a time. However, playback of music
and phone operation is only possible with one device at a time. Phone operation has
priority over playback of music; i. e. playback of music is interrupted during phone calls.
The following priorities apply during the use of playback devices:
Setting up multi point
• Pair the Aventho wireless with the first device (refer to “pairing with the player”).
• Deactivate the Bluetooth connection on the first device.
• Switch the Aventho wireless off.
• Press the button  for 6 seconds to start pairing mode (LED  flashes slowly alter-
nating blue and red).
• Pair the Aventho wireless with the second device (refer to “pairing with the player”).
• Re-activate the bluetooth connection to the first device that automatically connects
to the Aventho wireless.
• Once both devices are paired with the Aventho wireless, the Aventho wireless auto-
matically connects with both devices each time it is powered up.
Priority Profile Playback device (PD)
1 HFP (phone operation) PD 1 (device used first)
2 HFP (phone operation) PD 2 (device used second)
3 A2DP (playback of music) PD 1 (device used first)
4 A2DP (playback of music) PD 2 (device used second)