User's Manual

Setting up

4.5 How to record the Meeting

• For recording the meeting you can connect a recorder (e.g. a laptop

with the steno-s Conference and Recording software) to the

documentation output .

• The volume can be adjusted with a PC using the MCW-D 50 Conference

software.

• Instead of a recorder it is also possible to connect a headphone to the

documentation output . We recommend an impedance of 600 Ω.

Although a lower impedance does not damage the microphone unit, but

the headphone operation can be disturbed.

4.6 Maintenance of the MCW-D Microphone Units

• For cleaning the MCW-D microphone units when they are slightly dirty (finger prints, dust, jam or juice) use a soft, damp

cloth, sponge or brush and a liquid cleaning agent.

• Before cleaning the surface it must be moistened thoroughly. Afterwards it must be cleaned with a damp cloth.

• Make sure not to allow any water to enter the unit.

• For dirt caused by mineral oils and fats, animal and vegetable fats use spirit, isopropyl alcohol or benzine.

• For dirt caused by ballpoint pens, typewriter ribbons or carbon paper use isopropyl alcohol or spirit.

• Clean the charging contacts of the microphone units with spirit or isopropyl alcohol from time to time.

• Clean the supplied pop shield with clear water. Make sure that it is completely dry before you put it on the microphone

again.

4.4.2 FiFo-Mode

• If the microphone units operate in the FiFo-mode (first in - first out), the microphone unit that was switched on first, will be

switched off, when another microphone unit is switched on and the number of open microphones (NOM) will be exceeded.

4.4.3 Push-To-Talk Mode

• If the microphone units operate in the Push-To-Talk mode (PTT) the microphone button must be pressed as long as someone

speaks into the microphone.

4.4.4 Voice Activation Mode

• If the microphone units operate in the Voice Activation mode, the microphone units are switched on via voice control. That

is the microphone unit is switched on as soon as someone speaks into the microphone. In this case it is not necessary to press

the microphone button.

Important:

• The threshold and the hold time can be configured with the MCW-D 50 Conference software for all microphone

units.

5. Programmable Functions of the Microphone Units with the

MCW-D 50 Conference Software

The functions of the microphone units described in the following are only available, when they have been programmed

with the MCW-D 50 Conference software before. Please refer to the corresponding MCW-D 50 Conference Software manual.

5.1 Safety Code

Using the MCW-D 50 Conference software an alphanumerical code can be entered for the MCW-D microphone units and the

MCW-D 50 control unit within one system. This will increase the safety against unauthorised listening. Microphone units which

do not have this code are not recognised by the control unit and will be deactivated.