BEDIENUNGSANLEITUNG OPERATING INSTRUCTIONS NOTICE D’UTILISATION Opus 100 Drahtloses System Wireless System Système sans fil
OPERATING INSTRUCTIONS Opus 100 Thank you for selecting the Opus 100 wireless system. Please take some time to read carefully through this manual before setting up the equipment. The Opus 100 system has a single frequency in the VHF frequency range 174 to 236 MHz or in the UHF frequency range 798 to 862 MHz. 1. 1.
1.2 Antennae Fully extend the antennae and set them at an angle of 60° between each antenna. The two antennae are positioned this way to achieve the best pick-up reception. Setting up 1. Place the NE 100 diversity receiver in the same room or area as the transmitters. Ensure that the NE 100 is installed as close as possible to the mixing console or amplifier so that all indications can be seen at all times. 2. Do not place the NE 100 diversity receiver near digitally controlled equipment. 3.
1.6 Setting the Gain First adjust the gain of your transmitter (only TS 100; refer to chapter 3.3). Once the transmitter gain is optimised, it is necessary to match the receiver’s output gain to your mixing console or PA system. Adjust the gain control (5). Setting the gain too high may cause distortion. 1.
2. 2.1 SDM 159, SDM 169 and SEM 181 Handheld Transmitters Controls and Indicators (1) (1) (2) (3) (4) (5) Microphone head (fixed) Battery compartment Power On battery condition LED On/Off switch Mute switch (2) A L K A L I N E S I Z E A A A 1 . 5 V O L T S A L K A L I N E S I Z E A A A 1 . 5 V O L T S (3) (5) (4) On Off Mute On Off Power english SEM 181 V 2.2 Setting up 1. Switch on the NE 100 receiver. 2.
7. To avoid popping, try holding the microphone at a slight angle below your mouth. 8. To avoid covering the integrated antenna by your hand, do not hold the microphone at the microphone head as this could reduce the transmission strength. Furthermore, feedback can occur. 2.3 Maintenance Protect the microphone from humidity, knocks and shock. Avoid dropping the microphone at all times. If your microphone sounds dull, clean the integrated foam pop shield. To do this, follow the instructions below.
2. Connect the supplied microphone or instrument cable to the jack socket (4). 3. Switch on the beltpack transmitter by switching the On / Off switch (6) to the “On” position. The power on battery condition LED (5) is illuminated green when the battery has been inserted correctly and has full capacity. If the transmitter is properly working, one of the diversity LEDs of the NE 100 receiver should be illuminated. 4. Make sure that the mute switch (1) is switched to the “Off” position.
4.2 Before the Soundcheck 1. Make sure that the transmitter and receiver are on the same frequency (refer to type plate). 2. Check the transmitter battery and replace or recharge it if necessary. Use fresh alkaline batteries only. 3. Check the performance area for dropouts (i.e. areas where poor reception is encountered). If you find any dropouts try to eliminate them by repositioning the antennae or the receiver. 4.
5.
8. Versions Opus 100 V Opus 150 V Opus 154 V Opus 159 V Opus 169 V Opus 181 V Set consisting of: NE 100 V VHF diversity receiver, TS 100 V VHF beltpack transmitter, instrument cable and bag Set consisting of: NE 100 V VHF diversity receiver, TS 100 V VHF beltpack transmitter, MCE 60.100 clip-on microphone and bag Set consisting of: NE 100 V VHF diversity receiver, TS 100 V VHF beltpack transmitter, Opus 54.
9. Optional Accessories NE 100 Diversity Receiver 19"-Option ZTE 100/200 Shelf for 19"-rack mounting of one NE 100 receiver . . . . . . . Order # 457.051 SDM 159, SDM 169 and SEM 181 Microphones Microphone clamp MKV 11 Microphone clamp . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Order # 407.232 Stands GST 400 GST 500 Microphone stand, 3/8", height 0.90 - 1.65 m, with G 400 boom . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Order # 421.
SDM 159 V / U, SDM 169 V / U and SEM 181 V / U Microphones Polar pattern . . . . . . . . . . . . . . . . Supercardioid (SDM 169) / Supercardioid (SDM 159) Cardioid (SEM 181) Transducer type . . . . . . . . . . . . . . Dynamic (SDM 159, SDM 169) / electret condenser (SEM 181) Frequency SDM 159 V / SDM 169 V / SEM 181 V (VHF) . . . . . . . . . . . . . 1 frequency between 174 - 236 MHz SDM 159 U / SDM 169 U / SEM 181 U (UHF) . . . . . . . . . . . . . 1 frequency between 798 - 862 MHz RF output power . . . . .
27 english
