User's Manual

Synexis – Synexis TP2 Beltpack Transmitter
12
4.3 Battery status display
• The battery status is displayed  in 4 stages.
• If only one bar is displayed, you should recharge the receiver as soon as possible.
• If the battery frame is flashing, the batteries are empty and have to be replaced or
recharged.
• If the transmitter is equipped with rechargeable NiMH batteries, put it into the
appropriate charger (e.g. Synexis C8 or C10). Despite the Auto-Off function we
recommend turning off the transmitter before charging.
The LED  indicates the charging status:
LED is flashing blue . . . . . . . . . . The batteries are being charged
LED illuminates blue. . . . . . . . . . The batteries are fully charged
LED is flashing red . . . . . . . . . . . Error

 
L M H
4.5 Microphone connection
• Connect a microphone to the 4-pin mini XLR socket . Make sure the connector
will correctly lock in place.
Note
• In order to avoid popping noise in the Synexis RP2 receiver, you should connect
the microphone when the mute function  is activated or when Synexis TP2 re-
ceiver is turned off.
4.6 How to turn the transmitter on/off
• Turn on the beltpack transmitter with the on/off switch .
• The LED  will illuminate blue.
• The selected channel and the battery status are displayed .
• After use turn off the beltpack transmitter with the on/off switch .
• The LED  will go out.
4.4 How to set the gain
• With the 3-stage (Hi/Mid/Low) gain switch  you can set the gain for close or
distant miking. Remove the lid of the battery compartment  to access the
switch.
Position “Low” = set switch to “L”
Position “Mid” = set switch to “M”
Position “High” = set switch to “H”
4.7 How to select and lock a channel
• Use one of the two channel selector buttons  to select the requested channel.
• If you release the channel selector button , the channel will automatically be
stored after approx. 3 seconds.
• If you would like to lock the selected channel to avoid accidental shifting, hold
down the Set button  for about 3 seconds. A key symbol will be displayed .
The channel is locked.
If you would like to unlock a locked channel, hold down the Set button  for
about 3 seconds. The key symbol in the display  will disappear.
 

