User's Manual

Synexis – Synexis TS2 Stationary Transmitter
15
5.3 How to select and lock a channel
• Select a channel with the channel selector buttons .
• Press the up or down button  until the requested channel is displayed .
• Release the button  to store the selected channel.
• If you would like to lock the selected channel to avoid accidental shifting, hold
down the Set button  for about 3 seconds. A key symbol will be displayed .
The channel is locked.
If you would like to unlock a locked channel, hold down the Set button  for
about 3 seconds. The key symbol in the display  will disappear.
5.4 How to display the frequency
• Press the Set button  briefly.
• The frequency is displayed next to the channel.


Two transmitters - 19" rack mounting
• Remove the rubber pads from the bottom of the transmitter.
• Mount the connection plates on the top and bottom of the two transmitters.
• After joining the two transmitters together, mount the supplied brackets on the right and left hand side of the transmitters and mount
them in a 19" rack.
5.5 Mounting the antenna on the front / 19" rack mounting
One transmitter - mounting the antenna on the front
• Remove the rubber pads from the bottom of the transmitter.
• Attach the shorter one of the two supplied brackets to one side of the transmitter and the longer bracket with a hole for mounting the
antenna on the front on the other side.
• Connect the antenna cable to the antenna input  on the rear, pull the cable through the hole and mount the antenna on the front.