User's Manual

Synexis – Safety Instructions
4
Thank you for selecting the Synexis wireless tour guide system from beyerdynamic. Please take some time to read carefully through this manual
before using the system.
The Synexis tour guide system provides an optimum digital audio transmission for guided tours e.g. in factories or museums or in multilingual
conferences e.g. in conjunction with an interpretation system.
Synexis consists of the following components:
• Synexis RP2 beltpack receiver
• Synexis TH2 handheld transmitter
• Synexis TP2 beltpack transmitter
• Synexis TS2 stationary transmitter
• Synexis C8 charger
• Synexis C10 charger
• Synexis C20 charger
• Synexis CHP charger
1. Safety instructions
General
• READ the operating instructions.
• KEEP the operating instructions.
• HEED all warnings.
• FOLLOW all instructions.
Exemption from liability
• beyerdynamic GmbH & Co. KG will not be liable if any damage, injury or accident occurs due to negligent, incorrect or inappropriate
operation of the product.
1.1 Synexis TS2 stationary transmitter, Synexis C8, C10 chargers
Location
• The equipment must be set up so that the mains switch, mains plug and all connections on the rear of the device are easily accessible.
• If you transport the equipment to another location take care to ensure that it is adequately secured and can never be damaged by being
dropped or by impacts on the equipment.
Fire hazard
• Never place naked flames (e.g. candles) near the equipment.
Humidity / heat sources
• Never expose the equipment to rain or a high level of humidity. For this reason do not install it in the immediate vicinity of swimming pools,
showers, damp basement rooms or other areas with unusually high atmospheric humidity.
• Never place objects containing liquid (e.g. vases or drinking glasses) on the equipment. Liquids in the equipment could cause a short circuit.
• Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus (including amplifiers) that produce heat.
Connection – Synexis TS2 stationary transmitter, Synexis CHP charger
• The device can only be powered with the supplied external power adapter connected to a power outlet.
Connection - Synexis C8, C10, C20 chargers
• The equipment must be connected to a mains socket that has an earth contact.
• Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from
the apparatus.
• Lay all connection cables so that they do not present a trip hazard.
• Whenever working on the equipment switch off all inputs and outputs to the power supply.
• Check whether the connection figures comply with the existing mains supply. Serious damage could occur due to connecting the system to
the wrong power supply. An incorrect mains voltage could damage the equipment or cause an electric shock.
• Please note that different operating voltages require the use of different types of power cable and plugs.
Please refer to the following table:
Voltage Power plug according to standard
110 - 125 V UL817 and CSA C 22.2 no 42.
220 - 230 V CEE 7 page VII, SR section 107-2-D1/IEC 83 page C4.
240 V BS 1363 (1984): “Specification for 13A fused plugs and
switched and un-switched socket outlets.”