User's Manual

Synexis – Synexis TH2 Handheld Transmitter
9
 
3.2 How to insert/replace the batteries
• Slide down the lid of the battery compartment  to open the battery
compartment .
• Insert the supplied NiMH rechargeable batteries according to the polarity marks.
Before using the transmitter for the first time, the rechargeable batteries inside
must be charged e.g. with the Synexis C8 charger. As an alternative you can use
two 1.5 V AA alkaline batteries.
• Close the battery compartment  by sliding the lid  to the top.
CAUTION
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.


H L
3.5 How to turn the transmitter on/off
• Turn on the handheld transmitter by pressing the on/off button  for approx.
2 seconds.
• The battery status, selected channel and mute function are displayed .
• After use turn off the handheld transmitter by pressing the on/off button  for
approx. 2 seconds.
3.4 How to set the gain
• Inside the battery compartment  you will find the gain switch  to set the
gain for close or distant miking. Remove the batteries first and then set the gain.
Position “High” = set switch to “H”
Position “Low” = set switch to “L”
3.3 Battery status display
• The battery status is displayed  in 4 stages.
• If only one bar is displayed, you should recharge the receiver as soon as possible.
• If the battery frame is flashing, the batteries are empty and have to be replaced or
recharged.
• If the transmitter is equipped with rechargeable NiMH batteries, put it into the
appropriate charger (e.g. Synexis C8). Despite the Auto-Off function we
recommend turning off the transmitter before charging.
Depending on the charger, the LED of the charger or the LED  indicates the
charging status:
LED is flashing blue . . . . . . . . . . The batteries are being charged
LED illuminates blue. . . . . . . . . . The batteries are fully charged
LED is flashing red . . . . . . . . . . . Error