User's Manual

Opus 600 – NE 600 Diversity Receiver
10
2.2 How to connect the antennae
Connect the antennae to the TNC sockets  and  and set them at an angle (60°).
Please note that for diversity operation both antennae have to be connected. A weighting circuit silently
switches the signal with the better S/N ratio to the output.
Important:
Avoid obstacles between antennae and transmitter; otherwise the reception could be disturbed.
2.3 Where to place the receiver
• Place the diversity receiver in the same room or area as the transmitters. Make sure the diversity
receiver is placed as close as possible to the transmitter.
• Ensure that the NE 600 is installed as close as possible to the mixing console or amplifier so that the
display can be seen at all times.
• Do not place the diversity receiver near digitally controlled equipment.
2.4 Connections
• Connect the Audio output to the corresponding input of the mixing console or amplifier. Use the
balanced Audio output , when you connect the receiver to a mixer/amplifier with a balanced
input.
• Use the unbalanced Audio output , when you connect the receiver to the “LINE” input of an
instrument amplifier.
• Make sure the Mic/Line level switch  is switched to the correct position.
Switch to “LINE”, when you connect the receiver to a mixer/amplifier. When connecting to a
guitar amplifier you should choose “LINE”, or the volume may be too low.
Switch to “MIC-IN”, when you connect the receiver to a microphone input.
Incorrect positioning of the Mic/Line level switch  can cause distortion.
• Make sure the mains voltage shown on the power supply unit corresponds to the local mains
voltage.
• Connect the power supply unit  to the receiver or the power cable to the power connection 
and to AC mains power.
   
  
NE 600 S
NE 600 D