Operation Manual

BEYERTONE

www.beyertone.com

7. Special settings and software updates

Both the CR-100 USB and the CR-200 can - if required - be set with individual

parameters differing from the delivery status. To do so, the CallRecorder PC software is

needed to create the individual settings and transfer them to the device.

The way of doing is different for both product versions:

•

With the CR-100 USB the configuration is directly transmitted via USB cable to the

unit. This is only possible, when the unit is connected via USB to the PC: Usually,

you first read the data from the unit, change the parameters required, and then write

the data back to the unit. Additionally, you can save the settings as a file on the PC.

•

With the CR-200 USB the CallRecorder PC Software creates a configuration file

which will be saved to the USB flashdrive stick. From here, the CallRecorder will

read the configuration upon start-up. You can start with a new configuration file, or

you can open an existing one and do changes. Additionally, you can save the new

settings as a file on the PC.

(The internal clock of the CR-200 will be set in a similar way through a special

configuration file, if needed.)

In both CallRecorder versions the individual parameters will be stored permanently, in

the CR-200 also then, when the configuration file should be removed from the flashdrive

stick later. If the CR-200 finds a new configuration file on the flashdrive stick, it will

replace the former settings.