Operation Manual

BEYERTONE

www.beyertone.com

7.1 CR-100 USB configuration and settings

You can configure the CR-100 USB’s properties and parameters differently to the

factory settings and thus adapt them to your individual needs. To configure the device,

open the ‘Configuration / Hardware’ menu item (right click on the CallRecorder symbol

on the taskbar).

The configuration menu offers you the following options:

•

‘File’:

•

‘New’: Create a new configuration (button: )

•

‘Open’: Open a saved configuration (button: )

•

‘Save’: Save the configuration (button: )

•

‘Save as’: Save the configuration under another name

•

‘Close’: Close the configuration window

•

‘Communication’:

•

‘Read Parameters’: Read the CR-100 USB unit’s configuration into the PC (button: )

•

‘Write Parameters’: Write the configuration to the CR-100 USB (button: )

•

‘Update Systemsoftware’: Upload new systemsoftware to the CR-100 USB

In general you should make configuration changes by first loading the current

parameters from your CR-100 USB, then altering the settings you want to modify and

finally writing the amended parameters back to the device. If you wish to create a new

file, please make sure to select the corresponding product version.

The save commands let you save the CR-100 USB’s configuration on your PC as a file

(with a ‘.crc’ extension) so that, if you need to, you can open it again at a later date and

transfer it back to the device.

NOTE: With the PC software not running (i.e. the yellow ‘USB’ LED is off), you can

restore the configuration of your CR-100 USB to the factory settings by pressing for

about 3 seconds on both of the buttons on the device until the red and yellow LEDs light

up and then release the buttons again. You can then restart the PC software.

The various settings of the CR-100 USB’s configuration are explained below. Please

note that here too you can get a brief explanation of each element via the software by

pressing the F1 key on your PC.