Operation Manual

BEYERTONE

www.beyertone.com

•

The ‘Record’ tab:

‘Enable call detection’ in the ‘Start’ section lets you choose whether a start trigger is

automatically produced by the CR-100 USB whenever the acoustic signals on the

telephone exceed a certain threshold. In the PC software this can automatically trigger

the start of a recording or automatically launch the record dialog window. Checking

‘Enable speaker’ predetermines that the CR-100 USB’s monitor function will be

automatically activated for every recording.

Under ‘Codec’, you can select either the so-called ‘a-law’ codec (Europe) or ‘µ-law’

codec (USA/Japan) for the recording’s ‘Audio format’. As a rule, your PC will be able to

play back .wav files of either format without any problems.

In the ‘Level’ section you can set how high the ‘Amplification’ should be of the audio

signal being received. Reduce this level if your recordings are distorted and increase it if

they are too quiet. Alternatively, you can also enable ‘Automatic level control’, set with

the desired action.

Under ‘End’, you are able to ‘Enable call-end detection’ and set the ‘Waiting Time’ for

the discard function immediately after the recording has finished.