Operation Manual

BEYERTONE

www.beyertone.com

7.2 CR-200 configuration and settings

You can configure the CR-200’s properties and parameters differently to the factory

settings and thus adapt them to your individual needs. To configure the device, open

the ‘Configuration / Hardware’ menu item (right click on the CallRecorder symbol on the

taskbar).

The configuration menu offers you the following options:

•

‘File’:

•

‘New’: Create a new configuration (button: )

•

‘Open’: Open a saved configuration (button: )

•

‘Save’: Save the configuration (button: )

•

‘Save as’: Save the configuration under another name

•

‘Close’: Close the configuration window

Important: A new or changed configuration must be saved as a “config.crc”-file on the

USB flashdrive stick. Only with this name the CR-200 will recognise it on start-up and

read the parameters. Additionally, you can save the configuration file to your PC.

The other way round, you can open an existing configuration to make changes in it.

If you wish to create a new file, please make sure to select the corresponding product

version.

Note: To restore the factory settings, you can press and hold both buttons on the device

for approx. 2 seconds while you switch the unit on. After releasing the buttons, the

„Status“ LED will flash 3 times yellow to show that the default configuration is being

restored.

The various settings of the CR-200’s configuration are explained below. Please note

that here too you can get a brief explanation of each element via the software by

pressing the F1 key on your PC.