Instructions / Assembly


[phone] • www.BeyondLEDTechnology.com

8
BEYOND
L E D T E C H N O L O G Y
LED LANDSCAPING LIGHTS
BOISE
TM
2nd Gen
(Figure1)
(Figure2)
(Figure3)
DIM- :PINK
DIM+:Purple
GND-:Green
ACN-:White
ACL-:Black
Function adjustment
5
5
(Figure1)
(Figure2)
(Figure3)
(Figure1)
(Figure2)
(Figure3)
(Figure4)
DIM- :PINK
DIM+:Purple
GND-:Green
ACN-:White
ACL-:Black
Pole
DIM- :PINK
DIM+:Purple
GND-:Green
ACN-:White
ACL-:Black
DIM- :PINK
DIM+:Purple
GND-:Green
ACN-:White
ACL-:Black
(Figure5)
1/2 ADJUSTABLE FITTER MOUNTING (1/2AM)
Step 1: Take the lamp out of package (Figure1);
Step 2: Finish wire connection according to the right mode of connection (pay attention to positive wire,
negative wire, and ground wire), and then put wire into lamp pole (Figure2);
Step 3: Loosen screws; adjust fixture angle as per actual demands and tighten screws later; Tips: Angle
of the fixture is adjustable (Figure3);
(pass the bracket through mounting surface, fix it with screws, then connect the wires as per proper wiring
requirements.)
Function adjustment
Step 1:Open the metal plug and with a screwdriver (figure1), Then slide the switch left and right to
adjust the CCT controller, Adjust the color temperature as required (figure2).
Step 2:After adjusting the required control function, tighten the metal plug (figure3).