Specification


Installation I:
1. Turn off the power
3. Remove the 1/2 end cap 4. Peel off the yellow sticker and paste it
on the round area of the bottom plate
5. Fix the bottom plate on the round plate
7. Fix the fixture by 2 screws, block up
the two holes with rubber plugs
8. Make sure good wiring and screws
fastening, then turn on the power
2. Remove the rubber plug and loosen 2
screws
6. Make wiring connection and make sure
the good protection
OFF
ON
OFF
ON
LEAD

[phone] • www.BeyondLEDTechnology.com

6
BEYOND
L E D T E C H N O L O G Y
LED WALL PACK
TM