Co., Ltd. A/V Receiver User Guide

Quick Setup

2-3. Service Scan

Before watching a broadcasted program, you need to scan all the

services first. The scanned services will be stored in the non-volatilizing

memory. Therefore you don’t have to scan the service again unless you

delete all the information of the service stored in the memory. If there

are no services scanned previously, the service scan page will be

presented automatically.

You can select the options for each item with a pop-up menu. Please

press the

button to get a pop-up menu.

Antenna DC (+5V) Power: You can supply DC (+5V, max. 100mA)

power to the indoor antenna through the antenna cable. Please make

sure that your external antenna is an active type, which means that

the antenna requires external DC power to enhance the sensitivity,

before you supply DC power to the antenna.

Scanning Range: You can scan over all channels (VHF and UHF) by

selecting the “FULL” option. If you want to scan over specific

channel(s), please select the “PARTIAL” option. In this case, you have

to set the start and end channels manually.

Start Channel: This menu will be enabled when you choose the

“PARTIAL” option. Please press the

button to select the start

channel.

End Channel: This menu will also be enabled when you choose the

“PARTIAL” option. The end channel must be greater than the start

channel.

DANGER

IF THE ANTENNA IS PASSIVE TYPE, THE DC POWER WILL DAMAGE

THE ANTENNA AND THE DP-S1 ITSELF.