User manual Hobby Eagle A3 Super II

[e-mail] 17
Read
After selecting the port, connect the controller to the USB adapter and wait until the initialization is done. Click
“Read” to read the settings to the software from the controller. After a successful reading, you can see the current
firmware version and data version of the controller in the lower-right corner of the form.
VERY IMPORTANT!
1． If you are going to connect the controller to the PC while the plane is power off, please disconnect all of the
servos to prevent the fact that the USB port or the controller is demolished by an excessive current.
2． Please wait until the initialization is finished before you operating the software.
3． The firmware version number of the program card and the config software are corresponding to the Data
Version that the controller is using. That means you don’t need to upgrade the program card or the
software if the data version number doesn’t change even if you have upgraded the firmware of the
controller.
Write
After making your change of the settings, click “Write” to save the modified settings into the controller. The new
settings will take effect immediately.
Firmware Update
VERY IMPORTANT!
1． Disconnect all of the servos from the controller and power off the plane before starting update. It is very
important to confirm that you have disconnected the power at the beginning, otherwise the update
procedure won’t work in the next steps.
2． Both the controller and the program card can be upgraded online using the update wizard.
3． The update wizard needs to get the available firmware list from the server, please make sure your computer
is connected to the internet.