Instructions / Assembly

-14-

[Connection of Wires]

1. Indoor unit (fig.12)

• Open the panel upwards and open directly to

the maximum.

• Open the electrical cover.

• Secure the connection wires to the terminal

block according to the wiring diagram on the

electrical cover.

• Press the connecting wire tightly with the

pressure plate.

• Close the electrical cover, secure the electrical cover with screws,

and close the panel.

Note: Some models may not be able to directly pass through the cable hole into the

electric control box, and the above steps need to be removed after removing the middle

frame.

2. Outdoor unit (fig.13)

• Unscrew the handle cover fixing screw and open the handle cover.

• Secure the connection wires to the terminal block

according to the wiring diagram on the handle cover.

• Press the connecting wire tightly with the pressure

plate.

• Put the handle cover back and fasten with the screws.

• If customers need to extend or replace the power

cord, please refer to Table 3 for specifications.

Table 3

Power

connecting wires

Sign

control wire

Power cord

Max Length 11yard 11yard 5.5yard

5K/7K/9K/12K Cross sectional area ≥0.00155inch² ≥0.00155inch² ≥0.00155inch²

16K/18K ≥0.00233inch² ≥0.00233inch² ≥0.00233inch²

18K/21K/24K/28K ≥0.00388inch² ≥0.00116inch² ≥0.00388inch²

9K/12K（115V）

≥0.00233inch² ≥0.00233inch² ≥0.00233inch²

Electric

Wiring diagram

Open

Fig 12

Handle cover

Screw

Wiring diagram

Fig 13