bhi bhi Radio Mate Compact Keypad for Yaesu FT-817, FT-857 and FT-897 Operating Instructions Radio Mate Contact information: bhi Ltd P.O. Box 136 Bexhill on Sea East Sussex TN39 3WD UK tel: +44 (0) 870 240 72 58 fax: +44 (0) 870 240 72 59 Page 12 sales@bhi-ltd.co.uk www.bhi-ltd.co.uk Radio Mate Operating Instructions. 1090-107D Issue B Radio Mate Operating Instructions.
Important Information B an k 1 Memory Copyright This publication, including all photographs and illustrations is protected under international copyright laws, with all rights reserved. Neither this manual, nor any of the material within, may be copied or reproduced without the written consent of bhi Ltd. Frequency (MHz ) Modulation B an k 2 Frequency (MHz ) Modulation 1 2 3 4 Disclaimer 5 The information in this document is subject to change without notice. bhi Ltd.
Appendix A - Blank frequency tables B an k 1 Memory Frequency (MHz ) Table of contents B an k 2 Modulation Frequency (MHz ) Modulation 1 2 1. Setup 4 2. Memory function 5 3. Modulation 6 4. Direct frequency entry 6 5. VFO 8 6. Tune 8 7. Other bhi products 8 3 4 5 6 7 8 9 0 B an k 1 Memory Frequency (MHz ) B an k 2 Modulation Frequency (MHz ) Modulation Appendix A Blank frequency tables 10 1 2 3 4 5 6 7 8 9 0 Page 10 Radio Mate Operating Instructions.
NES10-2 MKII Noise Eliminating speaker. 1. Set up. Connecting and setting up the Radio Mate. (See your radio user manual for more information on setting up the CAT interface). be Turn the Radiomate off Turn the radio on FT-817 - only Press Func button to enter sub menu set cat rate to 9600 Baud. Press and hold Func to store. FT857 & FT897 For the FT857, and FT897 press func button to enter submenu and set the radio to CAT mode. Check baud rate is 9600.
. VFO operation. 2. Memory Function 20 memories are available as 2 banks of 10 memories. When the Mem button is pressed a beep will be heard. One beep for bank 1, and 2 beeps for bank 2. The 10 memories in each bank are numbered 0 - 9. Pressing the Mem button will put the keypad in Memory mode. The LED will illuminate RED. VFO operation can be set as follows: to Swap VFO A/B press the . key VFO A=B long press of the . key Split VFO mode by pressing the Clr key.
3. Modulation. In this mode the keypad will select an operating mode at the single press of a button. Press the Mod for Modulation mode. The LED will illuminate YELLOW. Pressing the appropriate button i.e. USB, AM, FM etc. will change the radio over to that mode. For example with the radio reading to change to 145.400 press .4 Ent new reading is 145.500 145.400 Note: Entering .400 would also give same result. To change to 144.300 press 4.3 Ent new reading 144.300 (entering 4.