Manual

daVinci Printed Doc
82
Preparing Control Surfaces
Typically, there will be one or more dedicated computers connected to the network, with daVinci
software running, and user access to the control surface available via Login/Logout
. This requires
that the control surface first be sent
to the system.
The control surface is initially sent to the system by the Administrator, who can utilize certain
Application Controls
to prepare the control surface for the end-user. These Application Controls
would have been included in the control surface design, and assigned to a restricted User
Access Level. The Administrator can use these controls to put the control surface into a 'user
mode' (such as Full Screen), which the end-user cannot exit from. The Administrator will then
Logout of the control surface, leaving it active on the computer(s) for user Login/Logout
. NOTES:
Login/Logout may also be assigned to Application Controls on the control surface, which can be
made accessible to the end-user. Full Screen mode can be automatic whenever control surfaces
are opened or tested, as selected under Tools>Options>General
.