Manual

Nexia Manual LTR
Object and Layout Text
The size and appearance of both text and objects can be customized. Special Text Objects can
be placed into the Layout using the Text cursor on the Object Toolbar
. When selected,
Component & Text Objects display handles which can be dragged for re-sizing. Right-clicking
over an object provides a pop-up menu which includes the Edit Text option. Edit Text can also be
accessed for a selected object by simply pressing the Enter key. Text (and object) appearance
can be customized using the associated tools on the Format Toolbar
. Also, Line Objects (wires)
can have identifying text added (see Line Property Sheet
).
System Compiling Considerations
Once a system design is created (components placed & connected), the system can be compiled
by selecting Compile
from either the File Menu or the Standard Toolbar. Compile analyzes the
system design and indicates design errors if there are any. If there are no errors, Compile
proceeds and allocates the required DSP resources.
Although Compile is an automatic process, certain settings can be pre-determined to help guide
this process. Control blocks (i.e., those processing blocks that do not have audio inputs or
outputs) can be Allocated To Unit
, which assigns them to a particular Nexia device. This can be
useful to dedicate particular control functions to specific physical locations, for example, to have
all RCB devices wired to the same unit using a single cable.
Propagation Delay (also known as Latency) is an inherent time delay of the audio signals, which
increases with the amount of DSP processing and NexLink routing applied. Each NexLink 'hop'
(one-way transmission) produces 0.67mS delay. Therefore, system outputs can have different
amounts of propagation delay. Compile determines worst-case propagation delay for a system,
and applies Delay Equalization to synchronize all audio outputs. In applications where audio
output synchronization is not important (audibly isolated areas), then Delay Equalization may be
disabled on individual Input Output components (DSP blocks) or system wide. See Object
Property Sheet and Compile Options.
For visual aids in determining DSP block allocations, see Display Options. A system design file
must be compiled before it can be downloaded to NEXIA devices (see Send Configuration
).
Compile results may be reviewed at any time (see Tools Menu > Layout Compile Results).
Example of Compile results for a simple system
150