Instructions
Table Of Contents
- Index
- A Brief specification
- B Intended use
- C Technical Data
- D Name / Address / Support E-Mail / Phone number of the manufacturer
- E General Data
- E1 Assembly and installation advice
- E2 Convection and installation position
- E3 Description of connectors
- E4 Dimensioning the upstream power supply
- E5 Initial operation
- E6 Connection
- E7 Overview connector / counterpart with description / Scope of delivery
- E8 Charging time
- E9 Reverse polarity / Overload / Short circuit
- E10 Backup time
- E11 Behaviour in case of exceeding maximum backup time
- E12 Status LED
- E13 Software
- E14 Recommendations for a long UPS service life
- E15 Maintenance
- E16 Disposal
- E17 Disclaimer
- E18 Preventive measures and rules when operating the UPS system
UPSI-2406DP1 | UPSI-2406DP2
Revision 1-3
17
The devices comply with the IP protection class 20.
E General Data
E1 Assembly and installation advice
Installation and operation of this device is only allowed to be executed from qualified personnel!
The application must be separated from any power during the mounting process. Wires have to be connected
safely and must not have contact with sharp edges. Pay attention to correct polarity! Before commissioning,
check all the connections for correctness!
E2 Convection and installation position
Do not cover any ventilation holes by adjacent components. For this DIN rail versions, vertical mounting on a
horizontal rail (DIN rails according to EN 60715) is recommended in order to achieve the best possible convec-
tion of the UPS. Another mounting position is possible, but operation up to an ambient temperature of +50° C
or +65° C, respectively, can not be guaranteed.
The following distances to neighboring devices are recommended:
Left / right: 20 mm
Top / bottom: 50 mm