Operation Manual
- 13 -
Cleaning and care
Clean the Ice Cube Machine regularly.
If you are not using the appliance,
absolutely remove the water in it - by
means of the drainage valve :
➪ Remove the plug from the wall
socket.
➪ Place the Ice Cube Machine in such
a position that you can hold a suffi-
ciently large container under the
drainage valve .
➪ Hold a sufficiently large container
under the drainage valve .
➪ Open the drainage valve . The
water drains out.
➪ Close the drainage valve when no
more water flows from the valve.
➪ Leave the lid open until the Ice
Cube Machine is dry on the inside.
This will avoid the formation of
mould.
Before cleaning the appliance:
➪ Remove the power plug from the
power socket.
➪ Allow the appliance to cool.
➪ Should there still be water in the
appliance, pull the drainage valve
out and drain off the water.
➪ Clean all areas, surfaces and the po-
wer cable with a lightly moistened
dishcloth. Dry the appliance well
before re-using it.
➪ Do not use cleaning agents or sol-
vents. These can cause damage to
the appliance.
Storage and transportation
First allow the appliance to dry comple-
tely before before placing it in storage.
➪ Store the appliance in a dry place.
➪ Do not tip the Ice Cube Machine
during transportation or storage.
Disposal
Do not dispose of the appliance
in your normal domestic waste.
Dispose of the appliance through a regi-
stered specialist disposal firm or through
your community waste disposal depart-
ment.
Observe the currently applicable regula-
tions. In case of doubt, contact your local
waste disposal facility.
Warranty & service
The warranty conditions and the service
address can be found on the warranty
slip.
Kompernaß GmbH
Burgstrasse 21
D-44867 Bochum
www.kompernass.com
bifinett KH 670
KH670_EU 09.10.2006 8:33 Uhr Seite 13