Installation Guide
BIG ASS FAN 2025
WWW.BIGASSFANS.COM ©2014 DELTA T CORP. ALL RIGHTS RESERVED
6
1. Select proper angle irons
Follow the table below when selecting angle irons for fan installation. Note: Angle irons and angle iron hardware are not included with
the fan.
Angle iron span
(between mounting points)
Minimum angle iron dimensions
(W x H x T)
Number of angle
irons needed
6 ft (1.8 m) or less 2.5” (6.4 cm) x 2.5” (6.4 cm) x 0.25” (0.6 cm) 2
over 6 ft (1.8 m) to 8 ft (2.4 m) 3” (7.6 cm) x 3” (7.6 cm) x 0.25” (0.6 cm) 2
over 8 ft (2.4 m) to 12 ft (3.7 m) 3” (7.6 cm) x 3” (7.6 cm) x 0.25” (0.6 cm) 4*
*Two pairs of angle irons. Pairs should be placed back to back and fastened in center (see step 3).
Installing the Fan
WARNING: The fan weighs 70 lbs (31.8 kg). The fan should not be installed unless the structure on which the fan is to
be mounted is of sound construction, undamaged, and capable of supporting the loads of the fan and its method of
attachment. A structural engineer should verify that the mounting structure is adequate prior to fan installation. Verifying
the stability of the mounting structure is the sole responsibility of the customer and/or end user, and Big Ass Fans hereby
expressly disclaims any liability arising therefrom, or arising from the use of any materials or hardware other than those
supplied by Big Ass )DQVRURWKHUZLVHVSHFL¿HGLQWKHVHLQVWDOODWLRQLQVWUXFWLRQV
CAUTION: Do not install the fan from a single purlin or truss or junction box.
CAUTION: Unsupported angle iron spans should not exceed 12 ft (3.7 m).
Angle Iron Side View
(see table for dimensions)
Width
Height
Thickness
6’ (1.8m) or less
over 6’ (1.8m) – 8’ (2.4 m)
over 8’ (2.4 m) – 12’ (3.7 m)