Installation Guide

BIG ASS FAN 2025

12. Connect power and wall controller wiring

Plug the male wiring harnesses on the fan wiring into the female

wiring harnesses on the power supply cable and the controller input

cable as shown. Carefully tuck the wiring into the extension tube.

Power Supply

Cable

Power Wiring

from Fan

(3 wires)

Cover Plate Assembly Wiring from Fan

(4 wires, to be connected later)

Installing the Fan (cont.)

11. Secure safety cable (to angle irons)

WARNING: The safety cable is a crucial part of the fan and must be installed correctly. If you have any questions, call

Customer Service.

To secure the safety cable to the angle irons:

1. Route the free end of the safety cable into one of the two (2) holes in the Gripple

, and then pull the cable through the Gripple until

the Gripple rests at the top of the extension tube.

2. Wrap the safety cable tightly around the angle irons as shown, leaving as little slack as possible.

3. Route the loose end of the safety cable through the remaining hole in the Gripple and pull to tighten

Wall Controller Wiring from Fan

(8 wires)

Controller Input

Cable