Installation Guide

BIG ASS FAN 2025

Installing the Fan (cont.)

13. Install cover plate assembly

Plug the remaining male wiring harness from the fan into the female

wiring harness on the cover plate assembly as shown.

Ensure all wiring is tucked inside the extension tube, and then attach

the cover plate assembly to the extension tube using the Cover Plate

Assembly Hardware as shown.

Cover Plate Assembly Hardware (BAF-Supplied):

(2) 8-32 x 1/2" Flat Head Screw

14. Install lower cover mounting bracket

WARNING: Disconnect power to the fan before installing the lower cover mounting bracket and lower cover.

Attach the lower cover mounting bracket to the bracket on the bottom of the main fan unit using the Lower Cover Mounting Bracket

Hardware as shown. Loosely attach all three (3) screws, and then tighten them.

Lower Cover Mounting Bracket Hardware (BAF-Supplied):

(3) 8-32 x 3/8" Pan Head Screw

Ensure that the three (3) stator wires on the bottom of the main fan unit are tucked in securely before installing the

mounting bracket. Be careful not to damage the stator wires while installing the mounting bracket and lower cover.

Cover Plate

Assembly

Remove the protective plastic cover from the bottom of the main fan unit before installing the mounting bracket.

Lower Cover

Mounting Bracket