Instructions / Assembly

Power Supply
Cable
Power Wiring from Fan
(3 wires)
Cover Plate Wiring from Fan
(4 wires, to be connected later)
Wall Controller Wiring
from Fan (8 wires)
Controller Input Cable
Extension Tube Hardware
A
Single Angle Irons Double Angle Irons
WWW.BIGASSFANS.COM © 2015 DELTA T LLC ALL RIGHTS RESERVED.
16
9. Connect Power and Wall Controller Wiring
Plug the male wiring harnesses on the fan wiring into the female wiring harnesses on the power supply cable and
the controller input cable as shown. Carefully tuck the wiring into the extension tube.
Allow the extension tube to hang freely and balance
itself, and then tighten the Extension Tube Hardware
to 25 ft·lb (33.9 N·m) using an 8 mm allen wrench and a
torque wrench with a 17 mm socket.
Tighten all hardware securing the angle irons to the roof structure to 40 ft·lb (54.2 N·m) using a 3/4” or 19 mm
wrench and a torque wrench with a 3/4” or 19 mm socket.