Installation Guide

WWW.BIGASSSOLUTIONS.COM © 2015 DELTA T CORP. ALL RIGHTS RESERVED.
2
BEFORE INSTALLING YOUR FAN
Read the following pre-installation procedures and checks to ensure you have all necessary items for installation.
Tools
The fan weighs 150 lbs (60 kg). A suitable means for lifting the weight of the fan, such as a scissor lift, at least two
personnel, and the following tools will be required. Note: Depending on your application, additional tools may be
required.
☐ Standard wrench set
☐ Standard socket set and ratchet
☐ Torque wrench capable of 40 ft·lb (54.2 N·m) & 3/4” socket
☐ Phillips and flat head screwdrivers
☐ Standard allen wrench set
☐ 1/4” nut driver
☐ 5/16” nut driver
☐ #10 to #14 AWG strippers
☐ Medium channel locks
☐ Multimeter
Power supply guidelines
If you are unfamiliar or uncomfortable with the installation of electrical components, do not attempt to install the
fan without an electrician. This guide is merely a recommendation of proper installation.
✓ Circuit Requirements. Refer to the Technical Specifications section and fan label for appropriate circuit
requirements for your fan.
✓ Conduit. Controller output/motor input leads cannot share a conduit with any other controller’s AC supply feed.
Power wiring guidelines
✓ To reduce the risk of electric shock, wiring should be performed by a qualified electrician. Incorrect assembly
can cause electric shock or damage to the motor or controller.
✓ The electrical installation of the fan must be in accordance with the National Electrical Code, ANSI/NFPA 70-
2014, if applicable, and all local codes.
✓ If extending the controller output/motor input leads, use stranded wire.
✓ See the Wiring Diagrams & Electrical Guidelines section for detailed electrical requirements.