Installation Sheet

48375
ASSEMBLY & INSTALLATION INSTRUCTIONS
Ume/Griffin Semi Flush 121370
A753
1. Carefully unpack the xture (A) from the carton.
2. Mounting bracket (B) is shipped installed in xture
(A). Remove #8 screws (E) to separate. Retain
screws for later use.
3. Using two machine screws (not provided) attach
crossbar (B) to the electric box using oval holes to
orient xture.
Note: A new electric box comes with screws.
When replacing a fixture, retain the existing
screws for use with the new fixture.
4. Hold xture (A) close to ceiling. Using suitable
wire connectors (not provided) connect fixture
wires to supply (white to white and black to black).
Attach a pigtail lead to bracket (B) using ground
screw (C) and cupped washer (D) found in kit bag.
Connect all ground wires (bare copper or green to
bare copper or green).
5. Carefully tuck all wires inside xture (A), push
xture rmly against the ceiling.
6. Align holes in xture (A) with holes in bracket (B)
and secure with (4) #8 screws (E). For ease of in-
stall, start all screws before tightening completely.
Note: Be sure no wires are pinched between the
ceiling and the fixture.
7. See instructions on next page to complete instal-
lation.
(Figure 1)
To Install Fixture (Figure 1)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND
PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with
applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on xture. Use only recommended bulbs with xture.
Please Note: After installation extra hardware and accessories are possible; our kits are used on multiple products.
CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX PRIOR TO INSTALLATION.
3 OF 4
CAUTION: MAKE SURE WIRE CONNECTORS
ARE TWISTED ON SECURELY, AND NO BARE
WIRE IS EXPOSED.
A
C
D
B
E
MACHINE
SCREWS