User Manual
6
OPERATION INSTRUCTIONS
• If the operator is not uent in English, the product and safety instructions shall be read to and discussed
with the operator in the operator's native language by the purchaser/owner or his designee, making sure
that the operator comprehends their contents.
• Visual inspection shall be performed before each use of the stand by checking abnormal condition, such
as cracked welds, leaks and damaged, loose, or missing parts if stand is believed to have been subjected
to abnormal load or shock inspection shall be made by authorized repair facility.
• Equipment that appears damage or worn or operates abnormally shall be removed from service.
1. Use on hard level surface with less than 3 degrees of slope.
2. Raise Vehicle with suitable jack.
3. Adjust height by pulling up on ratchet bar.
4. The weight of the locking handle should secure the ratchet bar in desired position. To conrm this, simply
push down on the locking handle. Check to ensure ratchet is secure before loading.
5. Carefully position jack stands so that load is centered on stand’s saddle.
6.
Slowly
lower the vehicle onto the stands.
7. Check to ensure vehicle is secure before working on, around or under. When used to support vehicle, use
wheel chocks on all unlifted wheels in both directions to prevent inadvertent movement.
8. DO NOT jack or dolley while jack stands are supporting the vehicle.
TO LOWER LOAD
1. Ensure that all tools, equipment and personnel are clear before lowering load.
2. With suitable jack, raise vehicle clear of stands.
3. Carefully release stopper and allow ratchet to glide down to lowest position.
4. Carefully remove stands, then carefully lower vehicle with lifting device.