User Manual

Example: To Repair Sheet Metal Damage

1. Determine which direction the body panel should be moved.

2. Remove any obstructions that could be damaged or are in the way.

3. Connect the appropriate attachments to the Hydraulic Ram.

Note: When repairing larger body panel dents such as a piece of sheet metal, dented door, fender or

suggested use is the Rubber Head.

4. Attachment must also be in line with the direction in which the damaged area needs to be pushed. A

hard secure surface will be required for to apply pressure on opposing sides.

 A block of wood or a towel may be used to protect the sheet metal.

5. Aim the pushing end towards the area that needs to be repaired and slowly apply pressure with the

Pump Unit. Once contact has been made on both points of contact, step away as far as possible and

continue to slowly apply pressure to the damaged area until the desired bend has been made.

6. When the damaged area has been bent to the desired position, slowly turn the Release Valve on the

Pump Unit in a counter-clockwise direction to release the hydraulic pressure and remove the

Hydraulic Ram.